The Message Events dialog contains all event sensors that can trigger a camera action based on incoming messages.
In order to filter events, the camera provides an Event Logic: This dialog allows linking events to create logic events only if the linked events occur in a certain sequence and within the specified time frame. Another possibility to filter events is the Event Counter: It creates an event only if a certain number of events occurs within the specified time frame.
|Event Dead Time||
The event dead time defines a period of time (0 .. 3600 s) after an event during which no new events from the same profile are recognized.
By defining an event dead time you can avoid, for example, that a complex action (person walks through the active image area) triggers multiple events.
|Event Sensor Type||Description|
The camera can trigger an event when it receives an IP notification via TCP/IP:
Note: This feature is not available for Web and Basic models.
|Serial COM In||
The camera can trigger an event when it receives a message via the serial interface (RS232).
Click on the Set button to activate your settings and to save them until the next reboot of the camera.
Click on the Factory button to load the factory defaults for this dialog (this button may not be present in all dialogs).
Click on the Restore button to undo your most recent changes that have not been stored in the camera permanently.
Click on the Close button to close the dialog. While closing the dialog, the system checks the entire configuration for changes. If changes are detected, you will be asked if you would like to store the entire configuration permanently.
|cn, de, en, es, fr, it, jp, ru|